Fast, Crystal clear, Super strong, Universal, suitable for many materials, Resistant to temperatures between -20 ° C and + 70 ° C, Filling, Water-repellent, Resistant to chemicals, paintable. Suitable for fast, strong and invisible repair of many materials, such as earthenware, porcelain, glass, leather, wood, stone, metal, ceramics. Both with themselves and in combination. Not suitable for polyethylene (PE), polypropylene (PP), PTFE and silicone rubber. Preparation: Working conditions: Only applicable at temperatures between + 5 ° C and + 35 ° C. Product cures by mixing the resin and hardener. Personal safety: preferably wear gloves. Surface requirements: the surface must be dry, clean and free from dust and grease. Surface preparation: Degrease parts that must be bound with acetone. Roughen smooth surfaces (sandpaper). Tools: mix and apply with the synthetic spatula. Clean tools immediately after use with warm water and soap. Application Mixing ratio: (in volume) 1: 1 (other mixing ratios possible) Cover: 1 ml = approx. 1 cm² with a layer thickness of 1 mm. Instructions for use Press an equal amount of both components on the enclosed mixing bowl. Mix these two equal parts well with a synthetic spatula until a mixture with a homogeneous color is obtained. Apply the mixture, which remains workable at room temperature (+ 20 ° C) for about 5 minutes, as a thin layer on one of the two materials. Assemble the material and hold it in place for 20 minutes. Be careful not to move the parts until the glue has cured. Resin and hardener must not come into contact with each other unless for use. Advice Some types of plastics cannot be combined, such as polyethylene and polypropylene. This can be tested by holding a glowing copper wire against the plastics. Does it smell like wax? Then you cannot bind it. Use a piece of adhesive tape to hold the parts in place while the glue hardens. Points of attention Close well after use. For optimum performance, it is important to make a larger amount of glue and mix it well. The curing time depends on the temperature. Adhesive does not cure below + 5 ° C. AFTER USE: Stains / residue Remove wet stains immediately with warm water and soap. Cured adhesive residues can only be removed mechanically. Storage conditions Keep container tightly closed in a dry, cool and frost-free place.
