Instructions:
- Place a small amount of borax powder in a glass or porcelain dish.
- Gradually add water to the flux until a paste is formed.
- Apply a thin layer of the paste to the workpiece.
- Heat the workpiece evenly with a soldering torch.
- Add solder and heat again until the solder flows, then remove the flame immediately.
- Allow the workpiece to cool slowly for further treatment.
- Place the workpiece in a (safe) acid bath to dissolve and remove the flux.
Safety precautions:
Wear gloves and a dust mask when preparing the flux mixture. Work in a well-ventilated area to avoid inhaling fumes. The product contains disodium tetraborate (anhydrous), a substance that may cause irritation. Store this product tightly closed and out of reach of children and animals.
Hazard Statements:
H302+H312 Harmful if swallowed or in contact with skin.
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H360FD May damage fertility. May damage the unborn child.
Safety Recommendations:
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes; remove contact lenses if possible; continue rinsing.
P301+P312 IF SWALLOWED: If feeling unwell, contact a POISON CENTER/doctor.
P308+P313 IF EXPOSED OR CONCERNED: Get medical advice/attention.
P405 Store locked up.
P501 Dispose of contents and container in accordance with local/regional/national/international regulations.
Additional Information: For professional use only.
Contents:
25 grams.
Saftysheet
